WARRANTY AND CARE INFORMATION
Aqualite5 warrants that it will, on clean glass, cause water to visibly bead on the surface. Mineral spotting or buildup on the glass does not constitute a failure nor a warranty claim. If on clean glass and with proper cleaning water does not visibly bead on the surface, the manufacturer will arrange replacement coating to be sent to the registered address of the warranty in an amount deemed sufficient to coat that area.
Care & Cleaning Recommendations
Depending on local conditions and minerals content, please follow the below cleaning guide to keep protected glass clean, and for removing buildup from the coated surface.
1) For best results: Wipe down the glass after each use with a good-quality squeegee - OXO GoodGrips is an example of a good squeegee. This will reduce mineral spotting, keeping the glass cleaner between cleans. |
2) Once a week or as needed, wipe down the glass with a microfiber cloth dampened with white vinegar and a drop of non-abrasive liquid soap (hand, body, or dish). Rinse and dry. |
General Guidelines for Approved Cleaners
There are no specific products you are required to purchase in order to keep your glass clean. All you should need for beyond 5 years is a squeegee, a mild liquid soap, and white vinegar. There are no solvents that will damage the Aqualite5, and products such as Windex, SprayWay, Scrubbing Bubbles, 7th Generation, and Method are acceptable, however are not necessary.
Prohibited Products
Note: These may damage the coating and void any warranty
Do not use any abrasive products. These include any rough or gritty products, water spot removers, polishes, toothpaste, Norwex Cloths or scrub pads. Do not use chemical products with very strong alkalis of a PH over 12 such as modern mold removing agents containing a combination of bleach and sodium hydroxide.